- The camera would in rare circumstances stop responding or fail to record a video correctly if an attempt for video recording took place after the standby timer had expired then reactivated with set to 1920 × 1080 in the VIDEO RECORDING MENU.Added and to in the photo shooting and video recording menus.Ĭhanges from Previous Versions Changes from “C” Firmware Version 4.00 to 4.01.If this update is performed to a camera with a “C” firmware version 4.00 or later, the existing IPTC presets can be used after update without taking the above measures.Ĭhanges from “C” Firmware Version 4.01 to 4.10 Be sure to copy and load the IPTC presets individually via the method described above. Note that IPTC presets cannot be loaded if menu settings were saved to a memory card using > in a camera with a “C” firmware version 3.10 or earlier and loaded to the camera using > after performing this update. The saved presets can be loaded from the memory card using > > / > once the update is complete. Users who intend to continue using existing presets will need to copy them to a memory card using > > / > in the before performing the update. This is an intended consequence of improvements to IPTC presets. Performing this update from a “C” firmware version 3.10 or earlier will delete IPTC presets in the camera. Do not turn off the camera until the firmware update is complete. A progress bar will be displayed when the update begins, but when updating from a “C” firmware version earlier than 2.00 you may notice that it takes about 2 minutes for the progress bar to be displayed. This update takes approximately 6 minutes. Read the information below before proceeding.This update includes all changes made in previous updates.You will not need to download this update if the firmware listed above is already installed. Use in the to check the camera firmware version before proceeding. This service supplies software that can be used to update the Z 9 camera “C” firmware to version 4.10.Be sure you understand the terms of the agreement before beginning download. By selecting “Accept” and clicking “Download”, you are held to have accepted the terms and conditions of the agreement. This software update program is for the customer-owned product listed above (the “affected product”), and is provided only on acceptance of the agreement listed below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |